I installed a new SSD, I installed P3D v5 purchased 06/22 License ID 3292947, all good, program recognized, after launching the setup and activating the program I received this message....cnnot run vithout a valid schenery.cfg clik abort and reinstall the program, tried a few more times but it doesn't work.
Thanks, Silvano
installation
Re: installation
So I am assuming that you installed to a folder on the new SSD named something like this:
E:\P3D
E: as an example of the drive letter of the new SSD.
Did you:
1. Right-click on the installer and select "Run as Administrator"?
2. Create exceptions in your anti-virus for the folders where you installed P3D?
3. Turn off UAC (at least temporarily during the install)?
Jorgen
E:\P3D
E: as an example of the drive letter of the new SSD.
Did you:
1. Right-click on the installer and select "Run as Administrator"?
2. Create exceptions in your anti-virus for the folders where you installed P3D?
3. Turn off UAC (at least temporarily during the install)?
Jorgen
System: i5-12600K@4.9 GHz, ASUS ROG STRIX Z690-I motherboard, 32 GB 4800 MHz DDR5 RAM, Gainward RTX 3060 w/ 12 GB DDR6 VRAM, Windows 10 Pro.
All views and opinions expressed here are entirely my own. I am not a Lockheed-Martin employee.
All views and opinions expressed here are entirely my own. I am not a Lockheed-Martin employee.
